"can't
wait to get to my Chlorine Free Water"
"no
longer do you have to use bottled water to swim in Chlorine
Free Water"
|
Operation,
Pool/Spa System Ionization (Copper)
If
the Controller’s Ionization setting is 9, the system runs
full power to the copper plates as long as the pool filter
equipment is running. Use this setting to initially get the
pool up to the desired copper level as quickly as possible.
If the
Controller’s Ionization setting is 0, no power is applied
to the copper plates.
If the
Controller’s Ionization setting is 1 thru 8, the system applies
power to the copper plates for the first hour only. The lower
number provides lower power, higher number, higher power.
Use these settings to maintain the desired copper level in
the pool. Determining the correct maintenance setting will
require every other day copper level testing for the first
two weeks, and weekly thereafter.
At regular
intervals, plate polarity is switched to ensure equal wear
of the plates. The LEDs change colors (red and green) to indicate
the polarity change.
Oxidation
If set
to 0, no power is applied to the titanium plates.
If set
to 1 thru 9, energizes the titanium plates as long as the
unit is powered. Run this setting as high as possible. If
the pool water gets cloudy, skip oxidation one day, reduce
the setting and resume oxidation.
At regular intervals, plate polarity is switched. The LEDs
change colors (red and green) to indicate the polarity change.
This also helps keep the plates clean.
pH control
At regular
intervals, the system takes a pH reading and then dispenses
pH reducer as needed to maintain the pool/spa’s pH.
The pH reading
cycle takes 12 seconds, during which the Oxidation/Ionization
LEDs are turned off. This indicates the pH reading cycle is
taking place. Pressing the up pH button will initiate a pH
reading cycle.
Based on the readings, the system decides
if the sensor is working correctly or not. If the system decides
the sensor is bad, or that the readings are too high or too low, the display flashes the appropriate error code which indicates the the system and/or pool need attention.
|
"my
daddy loves me, he takes me swimming in Chlorine Free
Water"
|